This means that when you first plug in an Appliance Module which you have just purchased, it may in an ON or OFF state (the state it was in before unplugging it after factory testing). Appliance Modules have a “latching relay mechanism” and will stay as they were before the interruption. Power interruptions When the power is restored after an outage, Lamp Modules and Wall Switch Modules will normally be OFF. If the Intercom system has its own separate wiring it will not cause a problem. Intercom systems Intercom systems which send voice signals over existing electrical wiring may interfere with the operation of the Digital Clock Timer when the intercom is in use. If NONE of your Modules work in ANY outlet, not even with the Module and the Digital Clock Timer in the same duplex receptacle (top and bottom) the Digital Clock Timer may be defective. Try plugging the Module and the Digital Clock Timer into the same outlet. Check that the Letter Code for the Digital Clock Timer is set correctly (see page 13). Check that there is a time displayed on the Digital Clock Timer and that you have power to the outlet it is plugged into. If you can’t control ANY Modules from the Digital Clock Timer. If the Module doesn’t work in ANY outlet, not even with the Module and the Digital Clock Timer in the same duplex receptacle (top and bottom) the Module may be defective. Check that the Number Code and Letter Code on the Module are set correctly. If a particular Module won’t go on or off from the buttons on the Digital Clock Timer: Check that you have power to the outlet controlling the Module and the switch on the light or appliance is ON. If you can’t control the Module, contact for help. If the Module turns On and Off you can unplug the Module or Digital Clock Timer and move it to its permanent location. Plug the Module into the same wall outlet as your Digital Clock Timer, press the ON and OFF buttons on the Digital Clock Timer that correspond to the Number Code setting on the Module. Testing The Appliance Module Make sure the appliance’s switch is on. Caution: Observe the ratings on the label on the back of the Appliance Module. And of course it can be used to control appliances. 14 It can also control other types of lamps such as fluorescent or energy saving lamps, low voltage lamps, or lamps that include a dimmer control. If you can’t control the module, contact for help. Testing The Lamp Module Make sure the lamp's switch is on. Plug the Module into the same wall outlet as your Controller (see testing below). However, due to the nature of inductive loads (those using transformers to step down voltage to a lesser operating voltage, i.e.12VAC) up to 15A loads may be plugged into the Appliance Module (such as Landscape Transformers or other low-voltage lighting systems). The Appliance Module can be used to control an incandescent lamp rated up to 500W. It may damage the Module and/or the appliance and could cause a fire hazard. Caution: Do not connect an appliance such as a coffee pot or heater to a Lamp Module. It is NOT suitable for other types of lamps such as fluorescent or energy saving lamps, low voltage lamps, or lamps that include a dimmer control. UNUMBER CODE DIAL LETTER CODE DIAL Ratings Ratings The Lamp Module can be used to control an incandescent lamp rated up to 300W.Set the Black Number Code dial to any unused number. NUMBER CODE DIAL LETTER CODE DIAL Setting The Appliance Module’s Code (Modules sold separately) Using a small screwdriver, set the red Letter Code dial to the same Letter as your Digital Clock Timer. Setting up the Lamp Module Setting up the Appliance Module Setting The Lamp Module’s Code (Modules sold separately) Using a small screwdriver, set the red Letter Code dial to the same Letter Code as your Digital Clock Timer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |